step 1
Prepare your work environment. Organizing your tools and materials will help
you work faster and more efficient.
Cut 2 pieces of the oval chain 26cm each.
Two pieces of the Hexagon and round loops chain – 11cm each.
Step 2
Use 5mm jump rings to connect the Hexagon and round loops chain to the necklace base on both sides.
To close the chains use 6mm jump rings to connect the clasp on one side and the extension chain with the metal label and Swarovski stone on the other side.
Connect the two oval loop chains at the back of the necklace with 5mm jump rings.
Open and close the 5mm jump rings with the help of the plier tool and hang the metal flower at the center.
Step 3
Place the stone in the center of the stone setting and with the help of the setting tool bend the prongs towards the stone in order to embed it.
In this metal flower set the 29ss stone by pressing it inside until it sits straight and can't move.
Use a small amount of E6000 glue inside the metal flower and place the stone inside.
Good work!
The necklace is ready!
Enjoy your new beautiful Swarovski necklace.
Gita team.