Step 1: Preparing your materials
Prepare your work environment.
Organizing your tools and materials will help you work faster and more efficient.
Step 2: Making the center part of the necklace
Connect a 5mm jump ring on each side of the center piece.
Open the small loop of the Eye Pin with the plier tool and connect it to the loop at the end of the center piece.
Slide one bead on the Eye Pin and cut away the extra length you don't need with the cutting tool.
To connect the end of the Eye Pin to the Stone setting, make a loop with the Roundnose Plier tool.
Step 3: Creating the necklace
Use two pieces of waxed polyester cord - 25cm each, 42 natural Agate beads and a few 5mm jump rings.
Tie the cord on the jump ring and make two knots.
To close the knot, just heat the cord and the wax will melt so that the cord cannot be opened.
Slide 21 beads on each of the cords.
Make a strong knot on the 5mm jump ring at the end of the beads, and heat the cord to close it in the same way.
Open the small jump ring at the end of the beads and connect it to the 39ss stone setting.
Open 5mm jump ring with the help of the Plier tool to connect the extension chain and clasp at the ends of the necklace.
Step 4: Setting the stones
Place the stone in the center of the stone setting and with the help of the Prong pusher bend the
prongs towards the stone in order to embed it.
Use big jump rings to hang the Heart shape pendant on the loop in the center of the necklace.
Good work, The necklace is ready!
Enjoy your new beautiful Swarovski necklace.
Gita team.