The first step is setting the stones
Place the stone in the Center of the stone setting and with the help of the setting tool
bend the prongs towards the stone in order
to embed it
The next step is cutting the chains
We cut 5 pieces of chains in 5 different lengths:60cm,55cm,50cm,45cm and 40cm
We cut the chains using a cutting tool
I chose to cut three pieces of the black-gold
Chain and two from the cream-gold, but of course you can
change the color and the lengths as you wish
When you finish, combine all the five chains by sizes
Hold the 5 chains ends and with a help of a plaier tool
connect them with one 6mm jump ring
Repeat the same action with the ends that remain open
Connect a 5mm jump ring to each 6mm jump ring with which we use to connect
.the chains
Connect the two octagon and 39ss settings bases to the 5mm jump rings that we connect
in the previous step
.jpg)
Cut a piece 30cm length black- gold chain
.jpg)
Connect a 5mm jump ring in each end of the piece of chain that you cut in the last step
With a help of a plaier tool connect each end of the 30cm chain to each stone setting
in order to "close" the necklace
Enjoy your new elegant chic necklace
